No hay artículos en el carro
No hay artículos en el carroCombinación Arc y protección piso culpa de fallo (clase A) en un solo dispositivo. Equipado con una función de diagnóstico conocido como ahorrador de diagnóstico que indica el tipo de defecto que duran se produjo en el circuito.
PostieGeorge
Comentado en Canadá el 20 de marzo de 2024
A cost effective solution to meet code requirements for residential combination circuits.
David Staples
Comentado en los Estados Unidos el 25 de febrero de 2024
What I like about these breakers is they work like they should and their half the price on here then they are at your local hardware store. They have never blowed anything and they keep my electric running like it's suppose to run.Very good product!
Pickled Pink
Comentado en los Estados Unidos el 28 de octubre de 2024
It works!
Joseph D.
Comentado en los Estados Unidos el 23 de julio de 2015
Installed a new Square D 100 amp panel in my garage/workshop. The panel has the plug-on neutral bar which is compatible with the combination Square D CAFCI and GFCI breakers. The plug-on neutral is a great feature and the panel looks nice and neat when completed. The combo CAFCI and GFCI breakers are expensive but since I was installing the panel in a garage with several outdoor outlets, I wanted the combo breakers. This also eliminates the need to install separate GFCI outlets for code and safety compliance which reduces some of the cost. Square D is a great product and the plug-on neutral breakers are recommended if you are putting in a new panel.
ADB
Comentado en los Estados Unidos el 19 de julio de 2015
AFCI and GFCI built into the breaker. No separate devices to install in line. One place to go to test all of your AFCI and GFCI circuits. Arc-fault protection for the entire cable run, not just from an in-wall device onward. Trips instantly and reliably with simulated arc faults and ground faults at outlets. This device provides a very high degree of confidence in the safety of the circuits it protects. Looking forward to replacing my main panel with a QO plug-on neutral panel in the near future so I can extend this protection to the entire house, not just the circuits on the addition subpanel (although I'm slightly less excited about the cost, it's cheap insurance).If you haven't worked with Square D's innovative plug-on neutral system yet, you owe it to yourself to give it a try on your next residential panel job. No more neutral pigtails crowding the inside of your panel installs. Just a nice, neat install with hots and neutrals straight to the GFCI, AFCI, and dual-purpose breakers and ground to the ground bar. The inside of the panel looks so clean you'll feel bad about putting the cover on.My only, relatively minor complaint is that due to the size and relative heft of these breakers, gravity wants to pull them slightly downward when the cover is off of the panel (not to the extent of falling out or anything like that - just a very, very slight tilt. When the cover goes on, everything stays securely in place. Not worthy of a star downgrade, just something to be aware of.
Productos recomendados