No hay artículos en el carro
No hay artículos en el carro This is the strongest model for Nema 23 stepper motor, it with 1.8 deg. step angle (200 steps/revolution).
Each phase draws 4.2A, allowing for a holding torque of 3.0Nm(425oz.in).
Electrical Specification:
* Manufacturer Part Number: 23HS45-4204S
* Motor Type: Bipolar Stepper
* Step Angle: 1.8 deg.
* Holding Torque: 3.0Nm(425oz.in)
* Rated Current/phase: 4.2A
* Phase Resistance: 0.9ohms
* Inductance: 3.8mH+/-20%(1KHz)
Physical Specification:
* Frame Size: 57 x 57mm
* Body Length: 113mm
* Shaft Diameter: 10mm
* Shaft Length: 24mm
* D-cut Length: 20mm
* Number of Leads: 4
* Lead Length: 400mm
* Weight: 1.8kg
Connection:
Black(A+), Green(A-), Red(B+), Blue(B-)
Warning:
Make sure the motor connect to a constant current or chopper drive controller before you test motor.
Connecting the motor directly to a power supply will destroy the motor.
Jaime
Comentado en los Estados Unidos el 5 de diciembre de 2023
Buen producto, llega a tiempo y muy bien presentado.
person500
Comentado en los Estados Unidos el 14 de diciembre de 2019
Packaging was excellent, with in was included a small card with all the important dimensions you would need to fabricate a support/bracket system. I have ordered a ton of stepper motors so far from amazon, these are the biggest and best ones so far.
Alan Paris
Comentado en los Estados Unidos el 11 de agosto de 2018
If you're looking for this type and size of motor, these are the ones to get. I'm using them on a DIY CNC plasma table and they are absolute beasts. More than enough power for my needs. I'd rather have more and be able to dial it back than to not have enough.
Customer
Comentado en los Estados Unidos el 24 de julio de 2017
Very good product, and very good service. I wish they had different shaft diameters available, but that is by no means a flaw in the product.
G-coder
Comentado en los Estados Unidos el 24 de enero de 2017
These are my go-to steppers for most automation projects. Good torque for the size. Be sure to get a driver large enough. A 2 amp driver wont cut the mustard. The mount holes are blank for passing a screw through them, but are the perfect diameter for a 1/4-20 tap, if you need to mount into them. I have used them both ways without issue.
Productos recomendados
Mex $590.00
Mex $ 265 .00 Mex $265.00
Mex $252.00
Mex $ 138 .00 Mex $138.00