Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

Teyleten Robot MAX31865 PT100 a PT1000 RTD a digital placa convertidora de temperatura termopar sensor módulo amplificador 3.3V/5V para Arduino 3pcs

Envío gratis en pedidos superiores a Mex $600.00

Mex $465.09

Mex $ 251 .00 Mex $251.00

En stock


1. Soporta 100Ω a 1 kΩ (0°C) resistencia al platino RTD (PT100 a PT1000); (La resistencia del módulo utiliza 430R) 2. Compatible con conexiones de sensor de 2 cables, 3 cables y 4 cables. 3. Interfaz compatible con SPI; resolución ADC de 4,15 bits con una resolución de temperatura nominal de 0,03125 °C (variable con no linealidad RTD); 5. La precisión total se mantiene a 0,5 ° C (0,05% de la escala completa) en todas las condiciones de trabajo; 6 entradas VREF totalmente diferenciales; 7. Tiempo de conversión: 21 ms (máximo); 8. Detección de fallos integrada para aumentar la estabilidad del sistema: circuito abierto (RTD, cortocircuito RTD a voltaje fuera del rango o cortocircuito de los componentes RTD).


Bryan Boettcher
Comentado en los Estados Unidos el 4 de marzo de 2024
To use with the reference code for the Adafruit Arduino library and a 3-wire RTD, you need to cut the jumper trace on the "24 3" pads. The default configuration is for 2/4 wire RTD's, and this will cause the sensor to read off by a few hundred degrees. Cutting the trace and putting a solder blob over the center and 3 pads corrects it if you're using a 3-wire RTD.There is an additional solder pad to jumper underneath the negative side, "labelled 2/3 wire".In summary:4 wire RTD: no soldering3 wire RTD: jumper the 2/3 wire pad below the negative terminals, cut the trace on the "2/4 3" pads above the reference resistor, and jumper between center and "3".2 wire RTD: jumper the 2/3 wire pad below the negative, jumper the 2 wire pad below the positive, leave the "2/4 3" pads alone.
Andrew
Comentado en los Estados Unidos el 1 de septiembre de 2024
Boards are not rated for 5v even though they have 3-5v written all over them. Voltage regulator gets smoldering hot at 5v and then the chip is dead. Fried the first 2 by connect VIN to 5v and 0v to GND. Third one I tried at 3.3V and while it didn't get burning hot it also still didn't work. Chinese clone of an actual adafruit chip that doesn't work.
Productos recomendados

Mex $6,230.17

Mex $ 1,881 .00 Mex $1,881.00

4.4
Elegir

Mex $417.78

Mex $ 221 .00 Mex $221.00

4.9
Elegir