No hay artículos en el carro
No hay artículos en el carroInterruptor Gigabit paso PoE para exteriores de 5 puertos con entrada PoE++ de 1 puerto y salida PoE+ de 4 puertos
M. Knutson
Comentado en los Estados Unidos el 13 de marzo de 2025
I'm not certain if it's the switch, or the POE injector I chose to go with it (TP-Link TL-PoE170S), but after power outages, the unit will not reboot with devices attached to it. It shows no status lights until I remove all the cables, and then insert the POE source cable. It will then boot up, and I can plug in in the two POE cameras that it supports. Logging into the switch, I can see the cameras only use about 8w total, so I'm nowhere near the budget for either the switch, or the injector. Fortunately, the switch is at ground level, but we do have a fair number of outages, and this is a hassle.
oholic
Comentado en los Estados Unidos el 16 de enero de 2025
Needed a switch for my patio that could handle being exposed to the elements and didn’t need an electric socket near by. This fits the bill perfectly and since I’m already heavily invested in the Omada ecosystem, it fits in perfectly. My only wish is that they would just bump the price up a bit and chuck a POE++ injector in the box. I had to buy one separately since my switch doesn’t support POE++ and all my spare injectors are POE+. Anywho, this thing appears to work perfectly. It was painless for my Omada controller to adopt it and update the firmware. This is a very nice little switch. For my uses this will power two POE cameras, a POE access point and will provide a wired data connection to an outdoor smart TV.
Joe W.
Comentado en los Estados Unidos el 4 de agosto de 2024
Needed a poe powered switch that also could power 4 pi4's all from a single poe+ upstream port. On top of that, I wanted integration with the rest of my Omada network. This one actually fit the bill perfectly! I have no use for the outdoor/weather proof aspect of it and wish they had a desktop version. But I can deal with that part. The switch and 4 pi4's pull a total of 16.4W from my poe+ switch. each pi is using 2~3 W so the switch itself is only pulling 4~5W. A little on the pricier side, when a standard 8 port is $15 cheaper, but those don't do POE out, so that is worth a bit more. can't complain as there isn't anything else in the Omada line that does what this one does. And it's exactly what I need!Low power!POE powered!POE output on 4 portsManaged switch!Omada integration!perfect for what I needed it to be!
Chris
Comentado en los Estados Unidos el 13 de agosto de 2024
I bought this because it supports both VLANs and PoE pass-through. I'm powering this using PoE from another room in the house and this, in turn, powers three Unifi access points using PoE without any problems. I need VLAN segmentation, which this version supports.This switch can be managed centrally using their software, but I chose to instead manage it from its built-in web interface. I was pleasantly surprised by both the number of features exposed as well as the ease of configuring these; it was all very intuitive (if you're familiar with VLANs, in general). I'm also happy to report that it can be configured to route both IPv4 and IPv6.The case itself is also pretty good for an outdoor installation as it has protection that goes over the Ethernet ports, though I chose to install mine inside. I would have gone with an 'indoor' version of this if I could find one with the same capabilities for around the same price.
Delanie
Comentado en los Estados Unidos el 21 de noviembre de 2024
No complaints, works as expected. One thing to note is that it does not fully work with Ubiquiti POE injectors. This is an issue with Ubiquiti, not TP-Link. Ubiquiti injectors apparently do not conform to proper power negotiating standards. It will power on, but not negotiate more power beyond 15 watts
Luis Robles
Comentado en México el 5 de enero de 2024
Una gran ventaja es que sólo necesita alimentarse de un sólo cable de red tanto para datos como para energía. Bastante útil si quieres conectar más dispositivos por LAN, y te ahorras metros cable, en vez de jalar cables desde el Switch principal.
Productos recomendados
Mex $2,395.17
Mex $ 1,101 .00 Mex $1,101.00
Mex $1,347.00
Mex $ 538 .00 Mex $538.00