No hay artículos en el carro
No hay artículos en el carro Especificaciones:
Chip del driver: SSD1309
Interfaz de soporte IIC/SPI
Resolución 128×64
Tamaño de la visualización: 2.4 pulgadas.
Color de la visualización: blanco/azul/amarillo/verde.
Tamaño del módulo: 71 x 43,5 mm.
Tamaño del vidrio: 60.5 x 37.00 x (mm)
Área de visualización: 55.02 x 27.49 (mm)
Voltaje de accionamiento: 3.3-5 V.
Número de pines: 7 pines.
Ángulo de visión > 160°
Temperatura de trabajo: -40 ℃ ~ 70 ℃.
Temperatura de almacenamiento: -40 ℃ ~ 80 ℃.
Definición de interfaz SPI:
GND: Potencia a tierra
VDD: fuente de alimentación positiva (2.8-5.5V)
SCK: línea de reloj
SDA: Línea de datos
RES: Restablecer la línea
DC: Datos/Comando
CS : Chip Select
El paquete incluye:
2 módulos de visualización
Victor
Comentado en los Estados Unidos el 9 de enero de 2025
Had no issues driving these with a raspberry pico. Display is sharp and bright. Runs on 5vdc perfectly. I switched it to I2C without any issue at all
Norman Royal
Comentado en los Estados Unidos el 5 de abril de 2025
I bought these and I've used OLED displays before over SPI. To test, I draw a diagonal line from 0,0 to 127,63. But the test looks weird-- as if I got the height or width wrong by 2x or 0.5x.Maybe there are undocumented config commands needed? What's the right addressing mode (page mode, horizontal, or vertical mode?Can you post some working code to use it? TinyGo, CircuitPython, etc?
Morgan
Comentado en los Estados Unidos el 9 de diciembre de 2024
3 stars, as it is not the right picture. I was expecting these to have the header not soldered and for it to be in the center. These have the header soldered on the left side. So if this will not work for your design look else where. Other than that the price is good and they work.
Productos recomendados