Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

XRDS -RF KMR400 - Cable coaxial RF de 50 ohmios de baja pérdida sin conectores de 100 pies

Envío gratis en pedidos superiores a Mex $600.00

Mex $1,804.42

Mex $ 775 .00 Mex $775.00

En stock

1.Longituddelapantalladelproducto:100 Pies


Acerca de este artículo

  • Pérdida ultra baja: e cable coaxial kmr400 de 100 pies sin conector es de color negro y es un cable coaxial de pérdida ultra baja. E cable permite la transferencia de señales a grandes distancias con mínima pérdida de señal. Este cable KMR 400 es equivalente al cable LMR400.
  • Materiales de alta calidad: el conductor interior de este cable resistente es de aluminio recubierto de cobre, por lo que es eficiente y causa baja pérdida de señal. La chaqueta está hecha de PVC flexible y a prueba de agua que se puede utilizar durante mucho tiempo en los entornos duros en el exterior.
  • Longitud del producto: la longitud de este cable coaxial lmr400 sin conector es de 100 pies y puedes cortar el cable de acuerdo a tus necesidades. Se puede utilizar en casi cualquier aplicación donde las características de manejo y cuando se requiere escudo mejorado y baja pérdida.
  • Compatibilidad: este cable coaxial lmr400 de ultra baja pérdida está diseñado funcior con todos los dispositivos y atos con impedancia de 50 ohmios. Se adapta a conectores estándaro conector tipo N, conector SMA, conector UHF, conector BNC.
  • posventa: XRDS -RF es un fabricante profesiol en la producción de cables coaxiales. Cualquier pregunta por favor no dudes en ponerte en contacto con nosotros, y haremos todo lo posible para resolver tu problema.



Descripción del producto

KMR400

Características del cable coaxial LMR400

Este cable resistente de baja pérdida lmr400 de 100 pies se puede utilizar dentro del edificio o fuera de edificios. Funcionan con todos los dispositivos con impedancia de 50 ohmios. Este cable coaxial KMR400 es equivalente al cable LMR400. Puedes utilizar este cable para hacer tu cable según tus necesidades.

Tipo de conector compatible

  • Conectores tipo N
  • Conectores UHF
  • Conectores BNC
  • Conectores SMA
  • Conectores TNC

Especificaciones del producto:

Impedancia característica 50 ohmios
3GHZ VSWR ≤ 1.1
6GHZ VSWR ≤ 1.15
Atenuación de 3 GHZ ≤ 0.04 dB/FT
Atenuación de 6 GHz ≤ 0.06 dB/FT
Diámetro 0.4 pulgadas
Min. Radio de curvatura (instalación) 2 pulgadas
Frecuencia máxima de funcionamiento 6000 MHz
Temperatura de funcionamiento -40 a +80 ℃
Máxima resistencia a la tracción 21.3Ib Peak
Potencia 16,0 kW

El paquete incluye:

1 cable coaxial LMR400 de baja pérdida de 100 pies


Rick in PA
Comentado en los Estados Unidos el 16 de mayo de 2024
Using this for a 2 meter ham radio application. Running from my roof to my basement and didn't want a poor SWR due to mediocre cable. Easy to work with and jacket and shielding are well made.
Chris
Comentado en los Estados Unidos el 1 de noviembre de 2024
This coax is acceptable. But it does not perform as well as times microwave LMR 400 up in the 440 band UHF and higher. But it seems good for HF/VHF with minimal loss. It doesn’t meet ALL the specs that they give though and I have tried multiple pieces with my test equipment and have found it to not meet there specs, especially in the UHF band when I do a sweep test. But like I said, it is acceptable for HF and VHF, it is just as good as RG 213 or LMR 400 in that frequency range. Most ham radio guys do not buy their coax from Amazon, so it will work perfectly fine for the guys on CB radio that do shop on here. I was just checking out to see if there are any bargains available.
tk
Comentado en los Estados Unidos el 21 de junio de 2022
This coax seems to have decent build quality. The shield/braid is a lot thinner than LMR400--I don't have the equipment to test/verify the loss compared to LMR400. Installed 100' on a 2m/70cm dual-band amateur radio antenna, and it seems to perform decently. We'll see how it holds up to the sun and weather, but i'm confident it will hold up ok.
Tim
Comentado en los Estados Unidos el 7 de noviembre de 2022
Much more flexible than LMR-400. Is it the same quality TX/RX as the expensive stuff? I have no idea. But I know it's gotta be better than the bottom shelf stuff most Hams grab first and a lot easier to roll out and run than the even better stuff. Unless I start getting bad signal reports, this stuff will do great.
John T
Comentado en los Estados Unidos el 23 de septiembre de 2022
The KMR400 coax has the same specifications as the Times Microwave standard LMR400 cable but at about 1/3 the price. This cable is constructed similarly to the LMR400 and is similarly a very stiff cable. The cable is not like the Times Microwave UltraFlex version which is much more flexible and has a slightly larger power loss.The connectors solder easily to the KMR cable, but the outer shield wire seems frizzier the LMR. I measured the coax cable loss with a MFJ 259 analyzer and verified the loss was the same as specified which is the same as the LMR.I use this cable for all feedlines outside my ham radio shack. Inside, I use the LMR400 UltraFlex cable. For portable antennas, shorter feedlines and lower frequencies I use the MOOKEERF coax found on Amazon. The MOOKEERF cable is smaller, has more loss and is cheaper.
Productos recomendados

Mex $250.40

Mex $ 150 .00 Mex $150.00

4.3
Elegir

Mex $347.67

Mex $ 191 .00 Mex $191.00

4.8
Elegir