No hay artículos en el carro
No hay artículos en el carroJonathan
Comentado en Canadá el 25 de marzo de 2025
Exactly what I needed easy to apply
Paolo
Comentado en Canadá el 9 de enero de 2025
Great birch match. Easy to apply. Use a good iron, that won’t over heat, on dry mode. I used our household model. I did have to promise my wife that if I ruined it I would have to buy us a new one. 👍
Ben
Comentado en Canadá el 13 de marzo de 2024
Heat banding with an iron and then roll the banding with a roller to disburse the glue evenly. Had great results and adhesion. The joints in the roll can be a bit annoying. Watch out for those so they don't end up on an area that's well seen.
DFM325
Comentado en los Estados Unidos el 26 de diciembre de 2024
I made a bookcase from plywood and wanted a wood trim to cover the raw edge. This did the job beautifully. It has glue already on it so it was easy to apply was an iron. Once sanded, stained and finished, it looked great. If you needed this type of trimming, try this. It will do the job.
Shawn
Comentado en los Estados Unidos el 11 de julio de 2022
After over a year, the product has held up well for all my uses. I am ordering 2nd roll as I only have about 20' left from the last roll. I didn't have any parts that were unusable. Some of my pieces were applied to joined plywood that were 10' long. A few finger joints on short boards (2-3') would have been more noticeable because of viewing location or angles, so I chose to start after the finger joint and loose a foot of banding for a cleaner looking edge._________________________________________________I was hesitant to purchase this product after reading some of the reviews, but I have had no issues with it. I have used over 1/3 of the roll already and was able to use all of it. No flaws, missing glue or damage like some reviews claimed plagued their rolls. There are finger joints through out the roll, but that was expected. The joints are very clean, well adhered and not very noticeable on the finished product.The only issue I had, which I believe was user error were a few times the center bubble away from the edge, but this edge banding is slightly wider than the plywood. The plywood is almost 3/4 inch and if you lay the wood flat on a surface when still hot, being wider caused some bubbles. I was able to reheat and seal those areas and made sure to lay the fresh edge off the edge of my table until cooled and trimmed. Since not laying flat on the bench until cooled and trimmed, I have not seen this issue again.
Productos recomendados