No hay artículos en el carro
No hay artículos en el carro
- Modo de funcionamiento: normalmente cerrado.
- Puertos de entrada/salida: 3/8 pulgadas.
- Presión de trabajo: 0-1,0 MPa.
- Punta del émbolo: NBR.
- Medios adecuados: agua aceite aire
- Instalación: la dirección del fluido debe ser como se muestra en la flecha.
David Hill
Comentado en los Estados Unidos el 28 de abril de 2025
Seemingly Well built. I put on my air compressor tank to hold back any small leaks in my hoses during the night so the compressor won't run. I replaced a 1/4" solenoid valve which did an excellent job but did not let enough air thru so I bought this larger solenoid. It doesn't completely shut off the air from the tank. It allows the compressor to kick on 4-5 times in a 24 hr period. I am going to have to replace it with something, but be aware that it may not hold back your air/water supply.
nats
Comentado en Canadá el 25 de diciembre de 2024
Works great. Used it for 6 months, going on/off every day. I mistakenly thought that the 2W was 2 watts. It gets very hot so I'm guessing it uses more than 2W. Otherwise I am satisfied with this.
Outdoor Woodburner Service
Comentado en los Estados Unidos el 3 de octubre de 2024
works ok
Customer
Comentado en Canadá el 9 de agosto de 2023
Fonctionne bien un peu sonore mais très peu quand même
Florencio R.
Comentado en México el 4 de agosto de 2023
Es una válvula quen opera perefectamente, la tengo controlada por un RTU5024 para operarla de forma remota.
Jonathan W.
Comentado en los Estados Unidos el 6 de diciembre de 2023
Nice brass body. Using it on a sand blasting cabinet with electric foot switch. So far so good. Also arrived sooner than stated by 1 day.
Productos recomendados