No hay artículos en el carro
No hay artículos en el carroMás información del producto
Jacqueline
Comentado en los Estados Unidos el 21 de abril de 2025
I checked this in a regular outlet before installing to make sure it works before placing it in my ceiling. The motor & fan run smoothly. It was a perfect replacement for my Broan 688K. Super easy to install and priced appropriately. If any of my other bathroom fans give out, I'll definitely visit this seller to buy more.
SGCSmith6612
Comentado en los Estados Unidos el 6 de abril de 2024
This is the exact part I needed to replace a bathroom fan vent that was rusting out, and had failed after 23 years of use. Fits like a glove. Installation was a breeze, taking less than two minutes, and the fan is back up and running with nothing more than a step ladder and a flathead screwdriver.The new fan/motor design does increase the noise level over my original fan. There is a distinct high pitched hum produced, likely due to the new (cheaper) fan shroud design. With that said, it seems to move about the same amount of air, and it spins in a stable manner.Installation is simple. Make sure the switch to the fan is off, or turn power off to the bathroom. Unplug the fan motor from the NEMA receptacle (like a lamp). Press against the housing where the center tab is to disengage it. You may need to push up slightly on the fan to help free it, and also use a flathead screwdriver to assist with leveraging the fan housing out a bit. Once the tab disengages, grip the fan and pull it out of the housing. Check the fan's damper once the motor and fan are removed to ensure it continues to open and close freely, and it isn't broken. Installation is performed in reverse. Use the flathead screwdriver to assist with engaging the locking tabs, just in case your fan housing is a bit tight.As a pro tip: If you happen to get fingerprints or smudges on your ceiling, a Mr. Clean Magic Eraser will do wonders to clean your ceiling. I'd recommend having one handy to help clean up afterwards.
Bubbles From Below
Comentado en los Estados Unidos el 5 de agosto de 2022
Replaced the fan assembly that appears to have been in the ceiling since the Jurrasic Period. That old assembly said "Patent Pending" whereas the new one says "US and Foreign Patents", so that gives you an idea how old the orginal was. Even with this age difference, the new assembly was an exact fit, dropped right in (it has two small tabs that fit into slots in the housing and you just push up the other side until the tab on that side pops into its slot) and worked great. I measured the unit at about 7 1/8" aby 7 1/4", and in comparing it to the original, side-by-side, it was a dimensional match. That actual fan sound is louder, at 3.2 sones, than the original one, which states 2.0 sones on the plate. But the old one sounded like an aircraft on takeoff that was about to lose fan blades, as it had not aged gracefully. Even so, the louder sound is fine, and gives users of the bathroom extra "privacy" in that bathroon which is off the living room hallway. Considered buying just the motor/fan but opted to get the whole unit. Glad I did; it's more expensive this way, but simple to install. Recommend the unit.
Ricky P.
Comentado en Canadá el 14 de octubre de 2022
Just the size is not fit
Mircea Ivan
Comentado en Canadá el 9 de septiembre de 2022
Part was OK although there were fitting issues ( the installed housing was marked wrong , so I ordered a smaller fan plate , with a little bending I got it snug )
Productos recomendados
Mex $1,687.73
Mex $ 725 .00 Mex $725.00
Mex $2,038.00
Mex $ 815 .00 Mex $815.00
Mex $781.00
Mex $ 406 .00 Mex $406.00