No hay artículos en el carro
No hay artículos en el carro Se puede aplicar a los mismos enchufes y conectores de la serie.
Cantidad del paquete: 1 unidad.
Número de modelo: DKJ35-50;
Corriente nominal: 315 amperios.
Sección del cable: 35-50 mm2.
Cantidad del paquete: 2pieza(s)
Sebulke
Comentado en Alemania el 6 de enero de 2025
Der Artikel so wie beschrieben alles gut
Customer
Comentado en los Estados Unidos el 6 de agosto de 2024
Replaced a worn cable end on my machine with these and they fit great. I would recommend these if you are needing some.
Rick
Comentado en los Estados Unidos el 4 de mayo de 2024
Used to make a new ground cable. I found the quality great and the fitment in the welder socket tight and secure. If needed i would buy again as a very reasonable price for a high quality cable end.
Roger DeLano
Comentado en los Estados Unidos el 12 de octubre de 2024
Fits my amico 165 welder perfect. Good quality ,i would buy again
Ed
Comentado en los Estados Unidos el 24 de noviembre de 2023
Feels very well built. I made a ground lead for my welder but haven't had the chance to try it out yet. You can fit 3/0 cable in this connector with a minor modification. You only need to grind down the bottom of the set screw so the sleeve will slide over it. It fits in my machine with a nice fit like the expensive brand that came with the machine. I liked these so much I ordered a second set to make some other leads for the same machine. Just a little bit of silicone spray helps the shield slide right over the connector end. Without the spray it was pretty tough in the cold shop to get it to seat fully. If you have a warm work environment I doubt you would even need the spray.
Productos recomendados
Mex $354.00
Mex $ 159 .00 Mex $159.00
Mex $288.76
Mex $ 132 .00 Mex $132.00