No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Warren
Comentado en los Estados Unidos el 28 de marzo de 2025
Pros:Well engineered. It's very flexible in positioning both the support itself and the rod it mounts to. It slides up and down the length of the bracket that mounts to the fan, which is perfect for my purposes.Easy to set up.Unobtrusive.Rock solid.Cons:Not the most attractive support, but it does the job without drawing attention to itself.Needed a GPU support bracket for a 3.5 slot card in a Fractal Torrent. Turns out that's not a small ask. This support fits perfectly, is easy to assemble, and even includes a tiny level to make sure the card's even.
Matthew
Comentado en Canadá el 20 de marzo de 2025
Works as attended
Its8up
Comentado en los Estados Unidos el 9 de febrero de 2025
Case: Lancool 216GPU: 7800XT reference (Sapphire Pulse)140mm bottom case fansAll the screw holes lined up, it secures in place pretty well, provides sturdy support, and is a nice addition to a black case. I love that it came with two longer screws for mounting through the fan and into the case as opposed to some crappy inserts that would leave the fan floppy on that side. I have the motherboard mounted in the lower 'water cooling' configuration. The pole sticks up about an inch over the top of the GPU. This means it would work well for the air cooled config too.If all you want is a fan mounted solution with a minimal offset to take the weight off your GPU, this will work. Put this thing in your cart and stop reading here.My end goal is to have a rigid anti-sag solution utilizing the four 4mm screw holes on the end of the GPU. The end of the GPU lines up a couple mm short of the center of the lower case fan screws. This design was the only one providing a minimal offset plus the freedom to attach the pole anywhere along the length of the fan-mounted bracket. The greater offset afforded by brackets with two sets of fan mount holes may be handy for anyone trying this with 120mm fans, but you will be limited by which holes will be useful on the end of the GPU.I appreciate that this listing included the 8mm pole diameter measurement. After some searching, it seems an 8mm "MSCF Sliding Bracket Guide" (google image search that) is the only other thing necessary to complete a rigid mount. Language barriers exist, so it may actually be a JSCF sliding bracket. I dunno. Amazon does not have any, and I'm ordering by picture. The GPU screw holes are ~21mm apart, so going with the 70mm length bracket guide.
OneEyedWillie
Comentado en Canadá el 13 de febrero de 2025
I was trying to provide a support bracket for my 4090 in a somewhat confined case. This was absolutely perfect. It will fit in any case where you have the gpu mounted in a traditional position.
Kraken01
Comentado en Singapur el 26 de diciembre de 2024
Easy to install and easy to adjust.
Productos recomendados
Mex $561.20
Mex $ 308 .00 Mex $308.00
Mex $419.00
Mex $ 196 .00 Mex $196.00
Mex $492.87
Mex $ 261 .00 Mex $261.00
Mex $1,322.86
Mex $ 648 .00 Mex $648.00